We’re going to go ahead and jump right in here with Sam. The first thing you want to do is go ahead and cut your rubber to the approximate length. Or, like Sam did here, you can leave it on a longer roll and then cut it off when you’ve got it on the glass. Remember to start in the middle on the bottom side of the glass in the narrow groove the inside following the curve of the glass.
Now go ahead and get your small rope or even speaker wire works well for this. Starting in the bottom middle again, you need to feed it into the small groove. Make sure you leave about two inches hanging out at the start just like Sam did here. Once you have it in the groove all the way around, cut the rope or wire again making sure that you leave approximately two inches hanging out.
At this point, Sam and I are done and we’re going to go ahead and hand it over to Andy. Good luck and thanks for watching.
I’ve installed the lubricant. We’re using window cleaner here. And about any cleaner, ivory soap is good. Soapy water. This here is just spray away glass cleaner. We’re using that. Okay, this is ready to go in the door now. And I’m going to put the door in here with the rope to the inside, half and half. And lay the door in here. Like this here. I’m going to start by positioning it in one corner and work on across here.
And I’m going to start out here with one rope. I’ve got it in the corner pretty good. And feel underneath here to see if the rubber started on the inside. It feels very good. Okay, I’m going to come on around here. Okay, we use one side of the rope. Go one direction only. I’m kind of helping the rubber back on there. I’m going to push the window down in here. Come around the corner here. And then here.
Okay, we’re coming on around with this here. I’m going to kind of help the window back over. It kind of moves around as you install it here. You’re going to keep up with it. You don’t want to give it too much pressure. Kind of help it down. Come on around the corner here with the rubber. Make sure it’s sitting good. Doing very good. It’s coming right in the way I want it to. Come on around here.
Okay, now we’re coming up on the end of the rubber here. I’m going to work it back the other way with the other piece of rope that’s left. Okay, now we’ve got this basically installed at this point. Now what I’m doing here is I’m just fitting the rubber to make sure it feels good around the edge. You see where our seam has come together here. Sometimes you have to help a little bit to bring it together. You can do that by simply moving it around.
Okay, I’m going to move the door around. This side here. What I’m going to do here is just check to see if this inner seam is locked in. We’re good around there. This is completed at this point. We need to wipe the glass down. We have our door completed.